Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
mr millwood thanks for ur reply i have wrote like that only in my program(PORTC.0==1)....
if u want u once try that one using code vision avr software and simulate in proteus.....
---------- Post added at 15:50 ---------- Previous post was at 15:48 ----------
thanks dude for helping i have...
hi friend
i am working on atmega 32. i have small doubt when i am executing this small program by using code vision for generating code and i have used this hex file in proteus.
PROGRAM:
while (1)
{
// Place your code here
if(PORTC.0=1)
{
PORTB.0=0...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.