Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
My edge detection model simulation works fine in system generator for software part and displays the output :-) but after generating hardware cosim block and running the same model using virtex 2 pro board does not give any error but does not display the output at all.:cry:
Can any one help me...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
