Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Phase noise is usually characterized in the frequency domain. For an ideal oscillator operating at ωo, the spectrum assumes the shape of an impulse, whereas for an actual oscillator, the spectrum exhibits “skirts” around the center or “carrier” frequency (Fig). To quantify phase noise, we...
Phase noise is usually characterized in the frequency domain. For an ideal oscillator operating at ωo, the spectrum assumes the shape of an impulse, whereas for an actual oscillator, the spectrum exhibits “skirts” around the center or “carrier” frequency (Fi). To quantify phase noise, we...
I want to calculate the phase noise of voltage controlled oscillator in dBc/Hz.
this is the signal generated by voltage controlled ring oscillator in frequency domain.
I m designing a three stage ring oscillator in LT spice and getting a error in phase noise analysis
i use the syntax and getting error below:
Error on line 826 : .noise n1 v1 dec 100 100 500
Bad .noise syntax: .noise V(<out>[,<ref>]) <src> <oct, dec, lin> Npoints StartFreq <EndFreq>
Unknown...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
