Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I am new to pcb design. I am working at 220v. I have chosen track width as 86mil and clearance as 100mil. But the problem is the distance between two pins of an ic is around 100mil and these two pins has to be connected to 220v supply which did not satisfy clearance limit. Please help...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.