Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I need to implement floating point arithmetic in verilog. I am aware of the fact that verilog does not support floating numbers.
Any hints on implementation of floating point arithmetic in verilog would be appreciated.
Thanks!
I want to develop ARM microcontroller based data acquisition system.
Can anyone suggest me ICs for -
1. Temperature sensor for liquid measurement
2. Temperature sensor for body temperature measurement
Please, it's urgent
I have configured my LPC2148 as mass storage device. Have written USB stack for the same. I want to transfer readings of ADC which are stored in its Flash to PC in the form of Excel spreadsheet. I am totally unaware of how to do this. Can anyone help?
I get from question from PC 'Disk in drive...
I want to develop mass storage device using LPC2148.I am just referring code from Keil for USBMem. My problem is -
I get Get_descriptor command from PC to which I respond with device descriptor. On receiving 8th byte it generates Reset.
Then I get Set_address command. On response to it, I...
I want to interface output of LM35 to channel of on-chip ADC of LPC2148. How should i do it? I will require to use amplifier no? Please help. I have looked at formulae from some forums.
As i have mentioned many times on the forum, I want to develop a system that will sense signal through ADC, will store data and transfer it to PC through USB communication. Can I consider my device of the class - mass storage? I want to go for mass storage as Windows has driver defined for it.
I want to develop a system s.t lpc2148 will sense signal from its on-chip ADC. Data from ADC will be stored in memory of lpc2148 and will be transferred to PC through USB communication.
I am trying to write code for it. I am referring code from keil library for memory device. But still i am...
USB on LPC2148
Hi
I want to connect lpc2148 to PC and to to get note from PC 'New hardware found'. How should i do it? I am referring user manual of LPC2148 and USB Complete. But not getting any idea.
Pls Help!!
This is part of my final year engineering project.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.