Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
This is not an actual scenario. I am a beginner in analog field and it's a toy simulation. The 14pf is divided into two parts: 4pf is used as compensation capacitor, and connected to drain of M2, 10pf is the supposed load.
Could you elaborate a little on the "overdrive by appropriate sizing"...
Hi Srijesh:
Thanks a lot. It turns out to be something I need :-)
I realized that when V1 is either 1v or 2v, M1 is always turns off and will not change the output voltage. It is right?
By the way, could I use the same configuration to measure the slew rate, by calculating the slope of output...
Hi,
I am simulating a two stage opamp and try to measure the settle time connected in unity gain feedback. But has problem to carry through. The problem is I couldn't get the expected output transient response in the waveform when there is a step in the input. Who could take one minute to look...
contract job in singapore + asic
Hi,
Thanks for your reply.
But who has got the list of the IC companies in Singapore.
Added after 1 minutes:
By the way, do you know the OKI company division in Singapore, what is its major direction and what about its salary as a fresh graduate?
how to start working in singapore
I have over 4 years' experience in ASIC/SOC design and verification. I would like to find a job in Singapore. Is there any website having much employment information in this field. Also, who knows what about the ASIC/SOC design situation in Singapore?
Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.