Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear Jiro,
I'm facing the same issues as u explained above. I could read battery voltage and battery current, but remaining battery capacity is inconsistent.
How did u solve the issue? Could you please help me to come out from this stuff?
With best regards,
Sujay
Dear tiwari,
Even we are facing the same problem. We are using FTP-628MCL103#70-RB thermal printer for our project. All 6 strobes, paper sensor, thermistor signal and 4 stepper motor signals are pulsing fine. Now we stuck up with stepper motor rotation, we are following the same sequence which...
Dear all,
We are using FTP-628MCL103#70-RB thermal printer for our project. All 6 strobes, paper sensor, thermistor signal and 4 stepper motor signals are pulsing fine. Now we stuck up with stepper motor rotation, we are following the same sequence given in the datasheet. We opened the retainer...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
