Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello......
i tried programming my atmega 8.. i gave all my pins as output and all of them as high...but the output i am getting is only 1 volt.. why is this? is this enough to feed into a motor driver l293d?
Re: kee prog programmer
ya i tried it now..... tried in a different progisp 1.6.8v........... it burnt successfully there....... really gratefull for your help..........
Re: kee prog programmer
thanks for the reply.......
the programmer is marked mk2.......
i checked the connectivity b/w the uc and the programmer. it was fine.checked with new uc as well.did not work.i used progisp as well. it said unable to load libusb0.dll.i did not understand what you meant...
Hello,
I need help with my keeprog programmer.....
On trying to burn a hex file into it withavrdude gui it says cant open device "giveio"...
i tried with other burning softwares also but it also said cant find usbasp device....
The ld on the programmer is burning........
Pleasehelp me out........
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.