Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
thank you to all now i can able to send the message from the controller, actually the problem is with my controller only and not in the program the mentioned above program is correct only, now any one can help to receive the message from the GSM modem and and control the any device with that...
the (25th) transmition pin of the pic controller, but now what happeing means i connected my controller with the hyper terminal from my guidance advaise, im getting the some characters but not what i mentioned in the program, and aslo in microC software's hyper terminal
thank you for your answer , actually i used to check the output voltage at the output pin. when i use the atmel controller in keilc i saw the variation of changing the voltage. in pic i get just the 5 volt only without any variations
sir, actually i initiated the baudrate at the funtion "sendmsg()" i.e is im initiating the buadrate every time s started to send the new msg, actually my problem with this program is that im getting constant 5volt at the transmitter pin (PORTRC6), PLAESE KINLY HELP ME TO COMPLETE MY PROJECT...
hi gyus
im doing my project in pic16f877 controller in that im facing the problem in my usart program, i have written one program in that if i run the program in microC compiler means im not getting any error but then i dumbed into the controller im not getting any response from the tx pin...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
