Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thx for your reply.
Btw, U know how and where to fix the 3 hall sensors into the PMSG (drill a hole on the stator magnets?), and what measurement tools could be used to ensure they are separate by 120 mechanical degree?
Cheerss!!
Hey Umesh, Thanks for your reply.
But I am wondering, how to use the signal generated from the hall sensor compare with the supply voltage to the motor for determining the rotor position?
do you have any article I can refer to?..
Cheers !
Hi, do you guys know how to measure the rotor position (esp for standstill position) of a surface-mounted PMSG, I got to know how to meaure it if it is interior PMSG.. but I have no clue on a surface-mounted PMSG.
Cheers.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
