Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: Interfacing with PCI bus
I used a XC2C256 Coolrunner cpld and made simple PCI target image for it : Output was jtag connected to jtag pins of the fpga. Or you can use serial or parallel configuration pins, if you like.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.