Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello All,
I am trying to create a FRAM view for a large asic die (20mm by 20mm) in IC Compiler. Only the top most metal layer gets converted into terminal in the FRAM view, whereas the lower metals gets converted into shapes rather than terminals.
I think there is some problem with the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
