Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by srinims

  1. S

    Pads2007 - how to fanout the BGA Package in the design?

    pads2007 fanout Hi All, I am new to pads2007.. How to fanout the BGA Package in the design. Can be done while creating library???...... Please help me .... give guidence.... Regards, Srini
  2. S

    Dx designer to pads 2007 - how to transfer ?

    powerlogic to dx designer Hi all, I am using dx designer for schematic capturing..I want to import dx design in the pads2007 for layout. How to transfer from Dx designer to pads2007(layout). Please send me any guidence. Regards, Srinivas.
  3. S

    Ddr2 address bus routing

    ddr2 addressing Hi, For Ddr2 address is there any topology for routing.. I have attached the jpeg file which i had doubt. Please help me.. Regards, Srinivas. https://obrazki.elektroda.pl/88_1240375961.jpg
  4. S

    possitive power plane in pads

    Hi, In the pads 2007 how to make a possitive power plane. Please tell me step by step.. I am new to pads. Regards, Srinivas.
  5. S

    Pads 2007 - which plane(positive or negative) is better?

    Pads 2007 power plane. hi, In the pads 2007 which plane(positive or negative) is better. Please help me. Regards, Srinivas.
  6. S

    How to set a decimal points in pads2007

    Hi Ahar, Thanks alot.. i got it... Regards, Srinivas.
  7. S

    How to set a decimal points in pads2007

    Then also i m not able to get the decimal poins...only one decimal point is comming.. Regards, Srinivas
  8. S

    How to set a decimal points in pads2007

    Hello, I am using pads 2007 for layout. I have a problem in measuring(dimension). While measuring In metric only one decimal point is comming . I need minimum 3 decimal poins .. Please help me how to set a decima points. Regards, Srinivas
See more

Part and Inventory Search

Back
Top