Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
How to simulate RF Push-pull amplifier in matlab-rftool/Simulink/Code. Anybody is having such simulations please share with me. Is there any book-matlab which supports above subjected simulations please provide me.
You need S2p parameters of the devices. Select rftool in matlab and load the input matching circuits,device S2p file and output matching circuits into the rftool. Then see the response at your required frequency. It is very easy to simulate but you need strong fundamentals abt the amplifiers.
Re: RF simulations- Matlab
Dear Khouly,
Thanks for your response. I know abt that softwares. I would like to know is there any possibility do with matlab.
Regards,
sri
12 to 24 dc dc converter design
Dear Max,
Thank you for your reply. My question is simple. Is the ripple current of the inductor has to be more or less ? Please reply me back.
Regards,
SRI
Added after 15 minutes:
Dear Max,
Thank you no need to reply my earlier question. I got the...
tps40210 .pdf
Dear Max,
Thank you for your reply. As per my calculation the inductor value should be 66UH for an inductor ripple current of 4A. But the link given by you if i calculated that is 3.6UH (17A inductor ripple current). Could you tell me please how much the Inductor ripple current...
dc dc convertor 20a 12 24
Hi all,
I would like to design DC-DC converter with following specifications.
Input : 12V from the car battery
Output:24V/20A
Topology: Boost converter
Voltage ripple:0.1%
Current ripple:4A (Iin become 40A as per calculation )
Operating frequency:100KHz
Delta...
For FM radios the least SINAD generally consider as 12dB. So you can use this value in the same formula. Care muste be taken as the bandwidth should be the demodulated bandwidth. For example voice it should be 1KHz. I think r u got it.
Re: How to Find Carrier
Set the centre frequency of the spectrum analyzer into your desired frequency, press trace button on the front panel menu. you will get a required frequency with some other frequencies, Use peak search marker. Then you get the required carrier freuquency.
antenna dipole design
Dipole antenna is for Low frequencies, 900MHz and 1800MHz the antenna become too much bulk. So go with omni directional antennas.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
