Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
If it using that much current you cannot use normal 78xx regulators. But as already mentioned it may be peak currents, so use some 78xx regulators with heat sink. Otherwise go for 723 ic regulators.
I have done a project in which i read the sms from a nokia 3310 mobile, and used it for some purpose. But i made use of fbus protocol, to communicate with mobile phone.
Some basic details of that you can find in the following link:
**broken link removed**
I am now doing a robotic project in which I have to implement vision. For that I decided to use 2 low cost cameras which have either parallel or serial interfaces. The board which I am using(ATNGW100) don't have a USB host, so can't use usb cameras.
Can anyone please...
image recognition by matlab
Now I am going to do a project in which I have to obtain a image from a µc to a pc and have to check that
whether those the images obtained are some symbols (that will be shown by a person with his hands) or not.
How could this be implemented, with the...
Derivative of a signal or function is its instantaneous rate of change. For a differentiator Capacitor connects the load resistor to i/p. Here small value of capacitor ensures that only instantaneous changes of i/p are coupled to the o/p. An eg. is a differentiator is used for generating impulse...
I think you could design a power supply with transformer, filter and regulator ic(like 78xx or 723) to get power required for driving the fan.
That will be the cheap but may not be as reliable as using an adapter.
Thanks to all you for giving such good replies. But I want to have a detailed picture of such problems. So can you please suggest a few links from where I could read more about such problems facing VLSI design technology?
Can any please tell me whether there is any considerable variation from Moore's law and if there are variations, what could be the reason(s) for that.
Also what are important changes that is made in the new ITRS? Especially what will be the effect of changing feature size to 45nm?
Can you please tell me which are the different problems that VLSI design technology is facing and what are the proposed remedies for these problems?
Can you suggest a few links or e books also if possible.
Thanks in Advance! :D