Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello guys,
I am designing a micro-strip line for 2.4 GHz in HFSS. I have found the trace width for 50 Ohm using the impedance calculator. I wanted to verify through simulation. I used waveports on both ends. And when I look into the S11, I can see that it increases with frequency and its below...
Hello everyone,
I am new to designing RF PCBs. In my design I need to connect one CPW transmission line layout to a mircro-strip one. Does someone know how to achieve this ?
Your help is greatly appreciated.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
