Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
the mikroc file
- - - Updated - - -
Sorry as I said I'm new to this, so I would like to know how to check the LVP whether it's enabled or not...
Thanks!
Hello,
I am new to pic programming and I'm not sure to know what you mean. I have opened the hex file as a note but I don't know what to check exactely.
Thank you!
Hello,
I use the pickit3 connected to the PIC18F4550 through target board. Each time I run Mplabx v5.15 it shows:
Device Erased...
""
Programming...
The following memory area(s) will be programmed:
program memory: start address = 0x0, end address = 0x97f
configuration memory
program memory...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.