Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
HI,
Recently i have installed hfss ver11 and ver12, both having the same problem when i try to open any hfss project file.
hfss has encounter problem and need to close.
Can anyone provide info regarding the above issue.
Thank You.
hi tjuby,
In order to understand the phenomena of the resonant mode frequency, you actually study the equivalent circuit of a general capacitor or the equivalent given by the manufacturer. it is clear that the first resonance occur are due to the series resonance between capacitor and the...
basics of ic design
can someone share softcopy of those books.
can anyone suggest link where i can find lots of ebook like the one we have here once upon a time.
pi filter
instead of using LC to block the rf signal and at the same time supplying the dc to the circuit i would like to used a pi filter for a more effective rf blocking, can someone provide me some guidance or information on how to design a pi filter, if i have my termination of 50ohm on the...
Re: crystal filters
common pratice is to put a back to back diode b4 the input matching of the crystal filter, that should limit ur input power to about few dBm.
recently i have facing half frequency oscillation in my power amplifier design.i am using a splitter/combiner architecture.can someone provide some information regarding this problem.
wilkinson power splitter
quarter wave length mean phase=90.however , the length is too long for my operating frequency of 900MHz.is there any way i reduce it maybe lamba/40?
i would like to design microstrip transmission line.can anyone explain how to calculate the power handling of the transmission line.i would like to know the minimum line width for a given power input.
cpwg momentum
can anyone guide me how i can simulate the CPWG using ADS momentum, coz for CPW the port setting is different from the microstrip transmission line.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
