Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I'm not sure what problem exactly you have with MALAB transfer functions but here is a procedure we followed to inverse engineer a complex circuit.
1- We had the schematic for the analog circuit.
2- We analyzed the schematics in Orcad and exported their bode plots to matlab.
3- Used matlab...
Re: VCO Design and ADS
Hi
Create a new Analog/RF Network Design
On the menu Go to DesignGuide -> Oscillator-> Voltage Controlled Oscillator (VCO)
You will find many good simulation templates for starting your design.
Re: microstrip or cavity
The NATO C band
--------------------
The NATO C band is that portion of the electromagnetic spectrum between 500 MHz and 1000 MHz.
In this range of freqs microstrip structure becomes large and you can't design high-Q filters and it's better to use cavity filters however...
Octave Code
You can run octave codes exactly the same way you run matlab M Files. You should have a successful instalation of octave (under linux) although some built-in matlab functions are not supported in octave.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
