Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
How a 8-bit microcontroller like 8051 can communicate with a sensor which is sending a train of 32 bit data,where sbuf register is cutting out the stop and start bits for uart system............?
thabk u very much...can any body tell me da process to count only human by using ir transmitter receiver& what would be da approx cost of l293D ic to drive da motor....if anybody can get that dan plz give me da ckt diagrm...
---------- Post added at 19:55 ---------- Previous post was at 19:52...
can anybody tell me how can i count human being crossing a door with using a microcontroller,with less amount ...i wanna to do this for my total project..& how can i control dc motor with a microcontroller..plz help me...my email id is xxxxxxxxxxxxx@gmail.com[/email].
MOD: Anything may be shared...
Can 89S programmed using USBasp?
can anybody tell me what is the basic principle of status signal in microprocessor..s1 s0 & io/M..i make out the function of io/M.bt i hv not understand the combination of s1 so for opcode fetch,memory read,memory write..etc..for these operations they have the...
can anybody tell me what is the basic principle of status signal in microprocessor..s1 s0 & io/M..i make out the function of io/M.bt i hv not understand the combination of s1 so for opcode fetch,memory read,memory write..etc..for these operations they have the the combination like 1 1,1 0, 0...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
