Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
gas ion selstive sensors
Hi all,
I need to design a pre-amplifier for a CO2 sensor.
Does anyone know a good place to find out some background information on this type of sensor? The datasheet I have is not very helpful!
Rgds
We have used HFSS to model antenna's within the body.
WillEd's method is the way we have used when designing antennas for use on implants. We found keeping the structure simple shortens the simulation time without degrading the results.
However we also found with "body tissue" dielectrics with...
Hi
I need to design a very small vco with a nominal centre freq of 2.45GHz.
What I'm a little unsure about is which oscillator topology would be best to use.
Does any I have any recomendations baring in mind size is important here.
rgds
abm models for ads
How do I create a analogue behavioural model of a comparitor with hysterisis in PSPICE.
I need upper and lower thresholds of 1.25 and 3V.
Thks
mos rectifiers
hi
I'm designing an nmos bridge rectifier that will rectifiy a a discontinuous pulsed waveform.
I'm a bit new to MOS design and am not sure where to connect the bulk terminals so they don't go positve wrt the source. Could connect to the source I guess but is there a better...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.