Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by soudabeh

  1. S

    simulating glucose-insulin regulatory model in diabetics type 1

    Hello all, My project is about controlling the glucose level in diabetics type 1. I want to somehow improve the best controller in this area "model predictive control". I want to work with some models that is considered for glucose-insulin regulatory system. But I have a lot of problems for...
  2. S

    amplifying the output of a capacitance bridge

    thanks alot:-D
  3. S

    amplifying the output of a capacitance bridge

    hello, sorry I thought it was attached.
  4. S

    amplifying the output of a capacitance bridge

    hello all, I want to amplify the output voltage of the bridge(ΔVo) in the circuit which is attached. The amount of capacitances are 47 nanofarad in balanced state & the power supply is a sine wave with frequency of 2.6MHz & amplitude of 0.8 volt. I used a xr2206 ic for producing the sine wave...
  5. S

    capacitance bridge in order of nanofarad

    Hello all, I have a capacitance bridge that the quantity of them is in order of nanofarad.The power supply is a vsin with frequency of 2.5MHz. The problem is that when I connect the power supply to the bridge the voltage of the node connection will become zero.I will become gratefull , if...
  6. S

    [SOLVED] weatstone bridge with capacitance

    Thanks for your reply.My broblem was solved with it.
  7. S

    [SOLVED] weatstone bridge with capacitance

    Hello, I want to simulate a weatstone bridge with capacitance in orcad. But ,it takes two errors & says that the nodes between two capacitance are floating.The power supply is vsin with frequency of 100MHz. Please help if you have information about it. thanks....
  8. S

    How to program AD9910

    A part of my project is to make sine wave frequencies (with the range 30Mhz to 100Mhz).For doing it ,I want to use AD9910. But I don't know with which software & how it can be programmed. Thanks in advance....
  9. S

    [SOLVED] sine wave generator with frequencies 10-100MHz

    thanks for your answer
  10. S

    [SOLVED] Frequency multiplier analog circuit

    I wanted a chip that can make frequencies with range 30Mhz to 100Mhz .At first, I wanted to use a IC(AD9833) & put a frequency multiplier analog circuit after that.But now, Ifind a IC(AD9858BSVZ) for doing it.By the way, thanks for your answer.
  11. S

    [SOLVED] Frequency multiplier analog circuit

    I want to ask if anyone of you know how to design a frequency multiplier analog circuit.The frequency is 0.1MHz to 25MHz & I want to convert it to 0.4MHz to 100MHz.If anyone can help me i will become grateful.
  12. S

    [SOLVED] sine wave generator with frequencies 10-100MHz

    Hello I'm looking for a chip which can generate a sine wave with frequencies between 30MHz to 100MHz. On the other hand, frequency should be controlable & accurate. please help me:cry:
See more

Part and Inventory Search

Back
Top