Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by sotron

  1. S

    CPLD. EPM7032LC44-15 if it can be copied and programmed in new chip.

    Thank you friends for the help, as for the JTAG connector, no it doesn’t have one.
  2. S

    CPLD. EPM7032LC44-15 if it can be copied and programmed in new chip.

    EPM7032LC44-15 I would like to know, before going out there and buying a programmer, if this can be copied and programmed in a new one. I have a bad and a good one. Any help would be appreciated.
  3. S

    PIC PLC (PIC16F648A based PLC project)

    picplc Hi. Check this out cheap ready PLCs (boards) with PIC microcontrollers and with their program Parsic I think about 160 euro’s you can make easily a PLC. The program has AND,OR,EXOR gates, up-down counters, multiplexers ,analog inputs, compare, pwm in/out, ADD/SUB/MUL/DIV, uarts, LCD...
  4. S

    [SOLVED] Differences between logic mosfets and regular mosfets. Help.

    Hi. After searching a lot in the net, maybe not so well. I wanted to control a motor or heavy load directly from a pic microcontroller. People suggested a logic level mosfet which can be driven right out of the micro this is ok, others told me to look for Vgs Gate- source Voltage, but a lot of...
  5. S

    Scaling analog input 0-30v and sending it to LCD with PARSIC

    Re: Scaling analog input 0-30v and sending it to LCD with PA Parsic is a Visual pic programming-simulator software. You draw the schematic, simulate it and make a hex file which you can program a pic micro. Very fast and easy software, no writing, no programming knowledge. The attachment is an...
  6. S

    Scaling analog input 0-30v and sending it to LCD with PARSIC

    0-30v Hello everybody. For Parsic software out there. How can I scale it to show me 0-30volts. Parsic at 16bits analog input is 0 at 0 volts and 1023 at 30volts. Can any Parsic user help? please. Thank you. Sotiris.:|
  7. S

    Scaling analog input 0-30v and sending it to LCD with PARSIC

    new parsic Hello everybody. For Parsic software out there. How can I scale it to show me 0-30volts. Parsic at 16bits analog input is 0 at 0 volts and 1023 at 30volts. Can any Parsic user help? please. Thank you. Sotiris.
See more

Part and Inventory Search

Back
Top