Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you guys for your valuable suggestions. I made the required changes as said you and it worked well upto certain voltages. Further testing is still going on.
Apart from this I would like to know how can I give a short circuit protection to my load using the IC configuration?.
If that's...
Hi,
I have made the exact PCB based on the schematic given in the datasheet with minor changes in resistors to adjust the input and output as per my requirement. Apart from this have used two IC circuits instead of one, so I can get two different output from each of the ICs. Here i have...
Hi,
I am facing problem with my circuit which is designed with the help of LTC3895. My requirement for the output and input are as follows:
Input: 25 to 140V
Output : 20V 3Amp ( There are 3 parallel output slot each giving out 20V @ 1 ampere)
Even added a p-mos to give reverse polarity...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.