Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
10 pin vga
Hi all,
I am stuck in one problem can you please help me out of this.
I have to convert 15 pin VGA connector to 10 pin VGA connector for CRT.
Kindly suggest me how to connect it and also provide me the pin configuration of 10 pin connector.
Urgent!!!!!!!!!
Regards
Sonia
Re: GSM with COntroller
GSM is working with hyperterminal but i have to integrate it with external controller. for the communication between controller and GSm i need to connect all handshaking signals.but the problem is i am not able to write a code for handshaking signals ...
Plz help me out...
GSM with COntroller
Hi all...
I am stuck in one problem ...Please help me to solve it...
Actually i am working on GSM module and i am going to interfaced it with 8051 controller.The hardware part is working well but i am not able to do a serial communication(tx,rx,rts,cts,dtr,dcd) between...
sfp connector
Hi all,
I am working on Network switches.I have to interface SFP connector with Marvell switch chip ie. 88E6095.Could you please clarify ,whether i will interface SFP connector directly with SERDES port or need any fiber transreceiver?
ITS URGENT!!!
Regards
Sonia
how to use current amplifier
Hi all,
I am having a board with an interface that is providing 5V@1.5 mA to a Card Reader. I need to replace Card Reader with GSM module which requires 5V@2 mA. Can I generate the current required by GSM module from the existing circuitry by using...
Hi all,
what is the difference between analog supply/ground and digital supply/ground?How can we distinguished it at the time of schematic design and layout?
Re: memory
Hi,
I am working on a layer 2 managed switch.For providing management i have to add an external CPU.but for CPU configuration i need some memory..Can i use serial eeprom instead of FLASH?
Re: interfacing
A MARVELL controller having I2C interface act as a master,which i have to interface with MAXIM IC having SPI ACT AS A SLAVE.
Added after 7 minutes:
how can i make an interface between SPI and I2C :?:
interfacing
Hi all,
I am working on aproject where i have to interface two I2C.but at the microcontroller side i have only SPI.
Kindly suggest me a solution how can i convert SPI to I2C as soon as possible.
Thanks
Sonia
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.