Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Well, I have been checking this clock every few hours and right now it is 100% on time!!! I have come to three different conclusions.
1. It's possessed.
2. This was just my imagination or I am going off the deep side.
3. My 83 year old Mother in law next door is sneaking over here in the night...
Good morning everyone!
Well. I checked the clock at 6:30 and 9:30 last evening and it was right on. I checked it this morning at 7:00 and both hour and minute hands were perfect. I am baffled at this now. So, I will update later tonight. If all of a sudden there is a change, then I agree with...
Thanks guys. I am doing a test and will check tonight. I did check the second hand and it is right on to the minute. Wouldn't it move faster? I reset the clock an hour ago so let's see what happens. I will post tomorrow. Bob
Hello!
I am new to this forum and cannot find anything that is the same problem I have.
I was fortunate to fine a nice advertising neon clock from the 1950's at a flea market last year and installed it on the side of my building. The clock runs and the neon works fine. However, after a few days...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.