Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi Guys
I wanted to know the difference between the Capless mode and the Legacy mode used in Headphone connection.
What my understanding is - in capless mode
Headphones can be used without the series ac coupling capacitors. and the Legacy is otherwise it is required to have the ac-coupling...
Re: Microphone Impedance
Hi FvM / Yadavvisi
Thanks for the answers.
What I am using is ECM type mic. its a small one (Dia 4.3mm x 1.3 mm) sitting on the pcb and connected to analog codec and then digital. its impedance is 2.6kohms.
What I understood is the mics with lower impedance can be...
Hi
I have a question on Mic impedance.
1. Why the mic impedances are so high. Like from 600 Ω to 10000 Ω. where speaker impedance ranges from 4 to 64 ohms etc...
2. How does the sensitivity of microphones are related to their impedance.
I am using very small mics on the pcb of phone sizes...
Hi Guys
I am new to electronics. I am basically a mech engg. but in my current job - I have been asked to the Audio-electronics stuff - which is good and i am enjoying it but need lot of help.
I wanted to know how the impedance in line effect the Audio Signals. In Phone design, if we have the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.