Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have attched a image file for transistor logic... will this logic work?
- - - Updated - - -
Thx... i have attached the proteus files and arduino source file and hex file. driving LED directly from arduino will require more output pins. Can you please check , what all changes are required in...
Hi, Thx ...
I have used stailess steel screw as electrodes. So there are 5 electrodes in the tank in vertical position to detect 5 levels. As you can see in the proteus image file, i have also connected a LED in series of 220 ohm resistor. So one leg of sensor goes to arduino Digital input pin...
Hi, my name is swapnil. I am trying to make a water level controller using arduino. I refered many circuit ideas for different website and made my own design. Simulated it in Protues and it worked fine. Also i designed my PCB in eagle and started implementing.
Everything was going as per plan...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
