Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear all..
Did anybody expert about above matter?
Actually i need to build a system using LIN..
and i dont have any experience using LIN.
I hope someone can help me to understand about LIN.
Thanks
USB to Serial
this evening i checked the voltage at the DB9 pin, at pin
2 and 3. i want to ask why it give the negative voltage?
than i test the voltage in 2 condition.
1. i checked the voltage at pin no 2 and 3 for connection using usb. than for pin no 2 i got -8.16v and pin no3 i got...
Re: USB to Serial
Firstly i want to tell about how i establish the connection.
First,i connect the USB to DB9 cable to my laptop. i already install the driver and
its just works fine. Than, from DB9, i connect it to the circuit like i attached (label JP1). The problem is, when i connect using...
USB to Serial
hi,
i already installed the driver for this.
ive test the connection using hyperterminal software and communication successfully done. but the problem occur only when i try to communicate with my diagnose software.
is anybody can help me with this?
please msg me if u dont clear...
USB to Serial
I want to write a code in vb6.0 using usb to serial cable using mscomm control in vb ,my code is working correctly without usb cable .i want to use usb cable through serial port cable connected to it.I am using USB Serial Adapter for it by i don't have DrIVER FOR IT WHICH IS asked...
tachometer calculation
Hi there,
I have a few question regarding the odometer and tachograph.
My first question:
" Why the tachograph and odometer readings are different? "
My understanding regarding this issues is the reading should be the same coz
it share the same input but current...
EEPROM Issues
sorry man..
i just realize i make a mistake...
actually its not about an EEPROM..
its about RAM...
Do u think i can hold the memory for about 30 minutes when there is no power?
(including hardware and software design)
sorry for my mistake..
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.