Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
another rpoblem that i encountered is that the taransmitted output when checked with a digital signal oscilloscope ggives very less output ie 500mv...this means that we are also getting even lesser output at the receiver ie 106mv...i cant figure out why is that so???again,when we try to connect...
im talking abt the reset at uc at which transmittr is connectd....the problem is dat the transmitted data at the txd pin does not get received at the rxd pin unless and until the RESET AT THE TRANSMITTER IS PRESSED...THE TRANSMITTED SEQ IS ASYNC ISNT IT...so that means that data shd get received...
its acually being sent over a 433mhz tx rx pair str 433...but the problem is that the sequence is not gattin received unless we press the reset switch on the transmitter...isnt it supposed to be asynchrinously receiving the sent info???...that means that as soon as it comes in the range of the...
but the problem is not with the reset...but the data is not being received p[roperly unless and until the rest at the transmitter is pressed...viz the data will not be received until the reset is pressed
plzz help...
yes we have 2 ucs -one having a transmitter and one with a receiver at the other end....and we are using txd and rxd pins for transmitting and receiving...
its acually being sent over a 433mhz tx rx pair str 433...but the problem is that the sequence is not gattin received unless we press the reset switch on the transmitter...isnt it supposed to be asynchrinously receiving the sent info???...that means that as soon as it comes in the range of the...
does the receiver uc at the receiveing end start receiveing only after the reset switch at the transmitter end is pressed......because we r receiving it properly until the reset at the transmitter is pressed....plzz help...its urgent :cry:
how is reception done in an 8051 uc...do we have to keep on resetting a ctsly transmting transmitter for the sequence to get received on the receiver????
---------- Post added at 15:24 ---------- Previous post was at 15:18 ----------
how is reception done in an 8051 uc???...do we have to keep...
how is reception done in an 8051 uc???...do we have to keep on resetting a continuosly transmting transmitter for the sequence to get received on the receiver????
how is reception done in an 8051 uc???...do we have to keep on resetting a continuosly transmting transmitter for the sequence to get received on the receiver????
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
