Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
modem g20
In AT commands reference there's written that MIPCALL command blocks terminal (EVEN AFTER answering "OK") until +mipcall is returned. If you try to send another command to the modem when it's still busy it'll abort and return "+mipcall: 0".
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.