Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Yes, I'm using a pull up resistor which is 4.7kOhm. What else should I consider? Should I add more pull up resistor? For yur information for 1 slave and 1 master it works fine with current in the power supply is 0.12A.
---------- Post added at 08:45 ---------- Previous post was at 08:43...
Hi all, I have face a problem during my lab experiment on I2C.
I'm using 1 master and 4 slaves. Each slaves is connected to 10 LEDs and I'm using switching method to ON all the LEDs.
The problem is after I give 3.2 volt power supply, the data that is produced from I2C can be seen but is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
