Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
when i try to install wind river workbench i get this error
what should i do??
!SESSION Fri Jun 12 18:22:02 GMT 2009 ------------------------------------------
!ENTRY org.eclipse.core.launcher 4 0 2009-06-12 18:22:02.745
!MESSAGE Exception launching the Eclipse Platform:
!STACK...
high voltage push button kv
i want to control a high voltage using 555 ic in monostable configuration
and the high voltage pulse should last until the output of the monostable will be high.
i am using the above circuit for timming.
how can i increase the spacing between the copper cladding and the wire route in eagle?
layout created by me
https://i208.photobucket.com/albums/bb118/sirish007/pcb.png
i want the spacing like this
https://i208.photobucket.com/albums/bb118/sirish007/eagle_export_image_5.png
100nk100
i am trying to burn the code into P89V51RD2 using FLASH MAGIC
but every time i get this error:--
UNABLE TO CONNECT AT THE SPECIFIED BAUD RATE.TRY REDUCING THE BAUD RATE.RESET THE HARDWARE INTO ISP MODE AGAIN
and i tried to communicate using windows hyper terminal and even that failed...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.