Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: ph meter using pic 16f877 pls help on coding
the motor B will start pump out in both condition(ph>7&ph<7) so only ph 7 stays.
Do i need a reset button to repeat the process.
Re: ph meter using pic 16f877 pls help on coding
this is my schematic
- - - Updated - - -
i have two motors,
motor a= inlet(c5)
motor b=outlet(c6)
motor a will pump in water until reach the high level then ph sensor check the ph value if the value is less or higher than 7 motor b will pump...
Re: ph meter using pic 16f877 pls help on coding
i am very sorry totally forgot about the other motor,
actually there are 2 motors.
Motor A for inlet and motor B for outlet.
the process starts when motor A pump in water then stop when the water reach high level, then ph sensor check the value...
Re: ph meter using pic 16f877 pls help on coding
so if i set up sensor(water level) on portD then the motor will be on portC then the ph sensor on
portA is it possible for u to provide me the code? but i need to run the motor as following the ph value and stop when the water reach high level.
Re: ph meter using pic 16f877 pls help on coding
ok my reading from my sensor is
2.54V for pH7 water.
so i want the water to maintain at pH7 if lesser or higher i will flush it out using a pump or a dc motor and at the same time i wanna control the water level so it wont over flow when the new...
Re: ph meter using pic 16f877 pls help on coding
https://tokoalatsurvey.wordpress.com/2013/03/22/probe-ph-meter-lutron-pe-3/
this is the pH probe i am using
Re: ph meter using pic 16f877 pls help on coding
here is my circuit
- - - Updated - - -
i am sorry abt that.......yeah i am using lcd 16x2 and my port B is connected with my lcd and abt control pins i am not sure abt it
Re: ph meter using pic 16f877 pls help on coding
i am using ccs compiler and my display will be ph value..................any help would be appreciated
- - - Updated - - -
i am using ccs compiler and my clock frequency is 20Mhz................my op-amp output is connected to RA2 and my...
hello i am doing a ph meter using pic micro controller project, i am done with the circuit using op amp to amplify the voltage range i receive from my ph meter now need to do some c programming for my pic 16f877.....is there anyone can help me to read the adc and display the value?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.