Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Another attempt:
Designing a CE Voltage divider circuit using Vcc = 15V
Choose Icq = 1mA for good current gain and frequency response and without causing undue heating.
Vbe = 0.7Volts.
For good quiescent current stability, Vre = 1/10 Vcc = 1.5 volts.
Hence, Re = 1.5/1mA = 1.5kΩ
For maximum...
Ok so here is one of my attempts:
Icq = 10mA
Vcc = 15V
A (Voltgae Gain) = 50
Vbe = 0.6 V (I’m not sure how to choose my Vbe because it is in a range)
Vc = Vcc/2 = 7.5 V (because then you get maximum symmetrical swing about Vc)
After all this is determined, I proceeded to calculate Rc and Re...
i am a first year student in electrical and computer engineering and my project is to design and build a single stage voltage divider amplifier with the following design specs:
1. voltage gain = 50
2. lower cut off frequency must be less than 100Hz
3. it must have maximum symmetrical swing
4...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
