Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
thank u very much !!
:D i used DFT compiler, thank u again~~~~~
now maybe i need more help
for module A, i use the scripts to insert scan chain :
set_dft_signal -view spec -type ScanDataIn -port [list ma_din[1] ma_din[2] ]
set_dft_signal -view spec -type ScanDataOut -port [list...
how to decide number of scain chains in a design
hi :
i am a new fish of DFT
now i have a question about DFT with " bottom-up "
struct of my design :
|Top
|------module A
|------module B
module B get the "clk" from Top
and divided the "clk" to generate "clk_1" "clk_2" and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
