Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi all,
I found the solution for loading the ST link firmware to STM32F103CBT6. I downloaded the STM flash loader demo. I connected the Rx Tx pins of a usb to uart cable to the Tx Rx pins (pin 30, pin31) of STM32F103CBT6 and set the Boot0 pin to high (3.3V). I run the STM flash loader and...
So I tried to bypass STM32F103CBT6. I used the STlink V2 to program the main controller STM32F407VGT6 via SWD and it works fine, this is good news.
ZASto I have no clue how to program STM32F103CBT6 as a debugger via STlink. I will google search it.
Thank you
Hello people,
I am looking to make a pillcam project and I want to integrate a small camera of at least 2MP. Unfortunatelly I haven't found any camera in SMD packaging. The one's I found are all with that flex pcb tape that take a lot of space.
Feel free to suggest some if you have the time
Cheers!
I haven't loaded anything in STM32F103CBT6 because it is not recocnized by my computer. I will try and use the STM bootloader that Klaus mentioned and see what happens. The architecture of my custom PCB is similar to the STM32F407G-DISC1 so another thing I can try is to remove the dicovery...
Hello, I have no code or clock setup because I haven't been able to get my device recognized by my computer so that I could load something. When I try to connect it I get the message ''Usb device not recognizable'' in windows. So everything is on factory default. For the record i took...
Hi all, I made a PCB board with STM32F407VGT6 (MCU) + STM32F103CBT6 (Debugger). I get the message ''Usb device not recognizable'' when I try to connect it to my computer via USB. I include the pics of my schematic. I followed the schematic of STM32F407G-DISC1. Any idea on what went wrong with my...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.