Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
its a drawing error. my doubt remains ..according to block diagram there is a delay to OVP, UVP ..a possible reason is mosfets bad drive . I check mosfets for damage but nothing found. I replace them , but chip remains in shutdown. maybe inductance of power inductors are wrong. unfortunately...
no output with a light load. pcb was replicated from AN1292 Texas application.
below are some components that I use in demo board.
LM5642 , TEXAS INSTR. vendor FARNELL code : 8181772
PSMN4R5-40BS , NEXPERIA vendor FARNELL, code : 2114728
RLF12560T-4R2N100 , TDK vendor FARNELL , code : 1669981
Hello to all !
getting some info from AN1292 (Texas application for LM5642 ),I made dc-dc converter to use at a solar controller. At test with no load the converter not work . no output, no pulses 200khz to drive mosfets. it seems to be disable ( on/ss pins below 2volts ). I was checked...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.