Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
by applying 10K resistor one set of leds starts turning on and off while on other set there is no effect. the arduino sketch is :
[code]
/*
The strobe (also called vertical sync) from a camera is broken out and
drives an interrupt on pin 3 (interrupt 1). The loop() uses the offset
defined...
Its an n-channel mosfet irf 530. i have 16 leds in each pair. 4 leds in series which are connected parallel to other 4 leds in series and so on. it will turn on all the time but when a pulse is applied on the gate it starts flickering. if i view them in camera and take picture simultaneously. it...
i am working on a project for which i need two set of ir leds to flicker alternatively with respect to each other with the same input frequency. the input signal is coming from the vsync of ps3eye camera. i have given the the vsyn signal to 555 timer. the output of 555 timer is being given to...
I am designing a tri band antenna in hfss but having problem with third dip which is at - 4ddB .... how ca i optimize it to get s11 below -10dB geometry is attached
please tell me how to create a fem model port in feko ... m having error "model port can be created on boundary of fem region" plz help me if possible sand me a link of some solved fem model port example thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
