Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Recently i bought an 8051 development board and i use to connect it with PC through com port but
The problem occurs when i use Flash Magic.When i press ' start ' in flash magic it says 'Unable to connect at the specified baud rate,Try reducing the baud rate.Reset the hardware into ISP mode...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.