Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Is this a low power DC/DC module? How much for the whole project? I usually live in USA. But the PCBA fabs I have found here have been very expensive unless it is mass producing.
I have sent some PCB designs to factories for prototyping. The price, however, varies greatly. Some ask 200USD for a four-layer 5cm*10cm PCB prototyping. While some only ask for 50USD. I assume that there are differences between these two factories. However, I could not find the differences...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
