Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi guys!
I need a bit of help to get the spectrum i want so that i can compare it to the results on a spectrum analyzer. Attached is the schematic and details that I want to set for simulation However I can seem to get the spectrum that I want. Can someone take a look and assist me in...
Hi guys,
I'm doing a project on FM-CW radar and I need a bit of help. I'm still new to ADS so I'm not sure how to go about simulating the radar. I want to obtain the spectrum from the mixer but how do I do that? Is there a spectrum analyzer function in ADS? Any help would be much appreciated...
Thank you for sharing, I am currently using IAR embedded workbench. I noticed that it's different from the example attached. Is there one for IAR? if not I will try to modify based on the example you have given me if it's possible..
hello....thanks again for the info, bigdogguru, I would use I2C if I could but for this I have to specifically use transceiver, software uart sounds like a good solution though it would be a big help if someone can guide me on software uart. I'm using C language to program the PIC by the way..
Hi...I'm using two pic and implementing a transceiver module. The problem is I need more than two uart as two is already in use for the transceiver and I need to connect RS232 to the PC therefore requiring the use of another uart. I'm wondering if anyone has suggestions to solve this problem. I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.