Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I got frustrated with this again today and realized that the error ONLY shows up with vias. Mostly pad to via, sometimes via to via, but never pad to pad. Again, my problem with this is that I currently have 251 reported errors. Of these, only a handful are real and I found one today that was...
This seems to be happening everywhere that I'm using this technique, the screen shot is just one example.
It doesn't seem to be an issue with a single footprint, but I'll look closer.
The copper is assigned to the proper net and pour over same net objects is selected.
I'm having an issue with connection errors and I can't figure out how to get rid of them, as they don't seem to be real.
screen:
I have quite a few power pours that are running on internal layers. I'm using copper on the top to connect the net to caps, resistors, beads, etc, and dropping vias...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.