Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
First of all, thank you very much for your answer, but I don't understand it very well. I did a transient analysis of the 4-fan inverter in HSPICE. This is my code. If I want to calculate the average current, I have to determine the value of tcyc. The part of 'from = to =' in meas, but I don't...
Can you give me an example about the current of the inverter, I'm not very clear how to write code, I'm still a novice how to use HSPICE is not very clear, thank you very much
1672664018
This is my measurement of the current of PMOS about X1. How should I mean it?
I understand you a bit, but I'm a novice, how do you write this part of the code in HSPICE? Can you give a demonstration? 'std. cell library' What is it? Where can I find this file? Thank you for your answer, the question of current measurement has been bothering me for a long time.
But if I put...
Isn't it DC SWEEP? I want to measure the current on the MOS tube? When I looked at the reference, I found that if I-V curves of transistors were to be obtained, VDS and VGS would need DC SWEEP.Like this.
In fact, if I use this PMOS and NMOS model to simulate a 4-fan inverter chain, the voltage output is correct. But I don't understand why the current looks wrong.This is a transient simulation output graph.But I used dc analysis to measure the current.
Here is my code and simulation, I simulated a 4 fan inverter chain, I don't know if the measured current values are real current values, why are they all so small? Is the code I'm testing wrong?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
