Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I think you are installing older version of hspice.
Newer one could be installed by GUI interface nowadays.
Please refer to the following link and find soultion.
Regards,
One important thing for dmos of BiCD process is the ultra low Ron.
This is could help you to design a project with higher efficiency under lower Vds.
Regards,
Re: **error**: model name n1 in the element 0:mnp4is not def
Your .sp called a 'max1573_umc_case0.lib' case0
But where is your .lib case0 delcaration on max1573_umc_case0.lib' ??
may try to modify this line
*******************entry the lib*****************************
.lib...
May try this fomat,
or create a run batch file as well.
#!/bin/csh -f
#
mkdir vlib
cat << EOF > cds.lib
DEFINE vlib ./vlib
EOF
van your_verilog_netlist.vpr -cds cds.lib -lib vlib
#
#
LOGLVS << END
case
tra 2000000
cir your_cdl_or_spi
nver vlib TopMost_Module
con TopMost_Module
sum
x
END...
Hello,
You don't have to convert verilog netlist to spice netlist for LVS check.
In fact, verilog netlist used to be the top most module/macro in the mixed-mode design.
Please also check these commands, "van" and "nver" and "con".
Regards,
problem when run DC.
Hello,
Looks like no lic be check out.
Please check both of your license server and local terminial envirnoment setting are correct.
Regards,
Hello,
Remote means that you could access the other machine's resource from your current one.
There has a way to run two os simultaneously on one machine, use tools like vmware, hummingbird shall be ok.
And if you just need to mount the linux directory that is hidded on windowsXP, then please...
Hello, not very sure whether you visit this web or not..
There exists how to Install the magic either.
http://www.opencircuitdesign.com/magic/
As I know, tcl/tk is necessary.
Regards,
.drf cadence foundry
Well, of course it is perfect if you would like to be an expert...
However, since you are new in the field of layout, to gain experience is more important than others currently.
Which means you are supposed to dedicate on the arts of layout, not in doing that.
Basically...
I met the same thing while doing as4 installation...
May try to hook up both cd-rom and hd under the same ide port.
Either primary or secondary shall work...
Also, please disable your sata driver option.
Regards,
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.