Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: Controlling Proportional valves using PWM
hii...i am very sorry..the LT Ic which i specified is wrong...it LT6108 is the correct IC which i want to use and NOT LT6101..very sorry
Controlling Proportional valves using PWM
hii...i am relatively newbie to electronics..
i have this circuit which works fine..i have attached circuit here...
the circuit has outputs CH_P and CH_N across which proportional valve (Burkert 2824) is connected
there is a low side current...
hiii rahdirs...
thanks a lot for ur reply...but i am looking for a single supply op amp...with the negative terminal grounded.
AD 8672 is again Dual Supply..
hii...
quick question...any one knows a replacement IC for OP2177 , with a single input supply of may be 3.3V, 5V or 12V.
These are the power supplies available on my board and i dont want to use any DC DC converter as well.
Or any website where i can find replacements.
Thanks a lot in...
Hello ALL,
I am currently working with my thesis and i use SMARTFUSION from actel(microsemi).Does anyone work with this FPGA cum microcontroller....?
I am trying to Interface User logic block(UART block) to MSS configurator through Core GPIO and APB3(AMBA) bus.Attachement shows the connection...
Re: Current measurement circuit
Hello,
I am currently working on my thesis,i am not very good at analog circuits.This is a small part of my thesis.
I have a circuit which is current measurement circuit.This circuit was already designed and tested by some ex-thesis student.Now i have to use the...
Re: Current measurement circuits
Thank you very much for your reply...
1.the supply voltage for the op amp is symmetrical power supply of ±15V.sorry for not mentioning in the previous thread.
so now what difference does this make for the values of resistors.
2.some additional info : the...
Current measurement circuit
Hello,
I am currently working on my thesis,i am not very good at analog circuits.This is a small part of my thesis.
I have a circuit which is current measurement circuit.This circuit was already designed and tested by some ex-thesis student.Now i have to use the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.