Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hello everybody...
m using code vision avr programmer...
i just want to ask u if anybody knows the code/syntex for storing a array of 8 values(values of 8 adc channel) in eeprom...
i havent implement this arrangement but i can suggest u a simple design...
use 5 diffrential gears linked one by one...
end one(1st or 5th gear) conncted to the driven shaft(tyres)...
after that use a worm wheel which can slide back and forth tangentially to the diffrential gear, touching its...
i have heard that rmp of stepper motor can be varied from few rmp to 10,000rmp!!...
bt the problem occurs when duration of pulse become less then the response time of the coil...
can anyone help me how to increase the rpm of stepper motor???
or is there any special stepper motor whos rmp can b...
u can use pulley system....
take a fixed radius pulley for driving shaft and for driven shaft take a conical pulley whoz radius decreases linearly....
make the conveyor belt to move along the width of the driven shaft pulley so that different radious can provide u different torque n speed....u...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
