Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i have designed antenna in HFSS. but my lumped port is not touching boundary of substrate (2mm away from boundary), and still i'm getting proper results in simulation. but, when i change dimensions of feed and put lumped port at boundary then i'm not getting any results.
so, if i keep that port...
i have designed "an aperture coupled microstrip patch antenna" using FR4 material. but for fabrication purpose i need to join two PCBs together. so, i'm looking for the same, the best adhesive to join PCBs with low dielectric constant. please help me out.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.