Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i am working on grasp9 for design of a single reflector antenna, i have radition pattern of feed horn calculated from another software, i am using tabulated feed pattern object to input the filed pattern of horn , i have used 5 phi cuts when grasp reads this file it reads two cut patterns but...
fss with cst
hello:
i am sending the model of my example with results, i am using the example explanied at page 19 of the pdf docment attached here. i am not getting the same results , please do tell me where i am making mistake.
While defining wavegudie port, when i give zpos at the surface...
cst waveguide for port is too short
Hi Piboo:
Thanks for your kind help. I am still confused a bit. i am using CStMWS version 4. I have read in this forum that i should define an embeded port but there is no option availabe for this , so kindly can you tell me how to define a waveguide port...
cst mw studio+frequency selective surfaces
Sorry same post was sent again by mistake, i will try to simulate with waveguide and hoping that ,will get some results
thanks
frequency selective surface theory and design
actually i want to simulate a subreflector which is reflective for infrared and transperant for ka band and it will be in far field of horn antenna thats why i am using plane wave simulation , i am trying to get frequency response by using probe...
waveguide for port number 1 is too short
actually i want to simulate a subreflector which is reflective for infrared and transperant for ka band and it will be in far field of horn antenna thats why i am using plane wave simulation , i am trying to get frequency response by using probe. if...
Hi
i am simulating fss in cst mw studio. First i am using the example discussed in PDF document "frequency selective surfaces " by REmsky in which we have an annular ring on a dielectric substrate . They have simulated it with hfss and got minimum transmission coefficient at almost 9 Ghz but...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
