Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am using 5V relay at Arduino Shield then on a 220 VAC Magnetic Contactor by this 5V relay. This Magnetic Contactor supply the inductor/X-former primary coil.
Dear All,
Recently I develop one project, which is "Induction Bearing heater". The project contain 16x2 LCD display with Arduino UNO R3. When press ON key then an inductor/X-former primary coil get 220VAC power, through a relay and the bearing getting warm as transformer secondary short...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
